GURU MCQs provides Civil Engineering MCQs for Job Test and Interview Preparation, suitable for fresh graduates, students, and competitive exams. Most repeated civil engineering MCQs section is frequently encountered in CSS, PMS, Inspector, ASI, Sub-Inspector, Constable, FPSC, PPSC, ETEA, FIA, Police, Army, Navy, Airforce, IB, MOFA, ASF, LHC, Educators, and various other competitive exams, as well as government and private job assessments. The most common updated MCQs include Basic Civil Engineering, Building Materials, Surveying, Soil Mechanics and Foundation Engineering, Applied Mechanics, Hydraulics, Waste Water Engineering, RCC Structures Design, Irrigation, Railways, Construction Management, Theory of Structures, Estimating and Costing, Docks and Harbours, Elements of Remote Sensing, Building Construction, Concrete Technology, Advanced Surveying, Strength of Materials, Water Resources Engineering, Water Supply Engineering, Steel Structure Design, Highway Engineering, Airport Engineering, Structural Design Specifications, Tunnelling, and much more.

101. For a well-conditioned triangle, no angle should be less than______________?

A. 20°
B. 30°
C. 45°
D. 60°

102. During chaining along a straight line, the . leader of the party has 4 arrows in his hand while the follower has 6. Distance of the follower from the starting point is_____________?

A. 4 chains
B. 6 chains
C. 120 m
D. 180m

103. The angle of intersection of the two plane mirrors of an optical square is______________?

A. 30°
B. 45°
C. 60°
D. 90°

104. Which of the following angles can be set out with the help of French cross staff?

A. 45° only
B. 90° only
C. either 45° or 90°
D. any angle

105. The permissible error in chaining for measurement with chain on rough or hilly ground is_____________?

A. 1 in 100
B. 1 in 250
C. 1 in 500
D. 1 in 1000

106. Normal tension is that pull which_______________?

A. is used at the time of standardising the tape
B. neutralizes the effect due to pull and sag
C. makes the correction due to sag equal to zero
D. makes the correction due to pull equal to zero

107. If the length of a chain is found to be short on testing, it can be adjusted by______________?

A. straightening the links
B. removing one or more small circular rings
C. closing the joints of the rings if opened out
D. all of the above

108. Cross staff is an instrument used for________________?

A. measuring approximate horizontal angles
B. setting out right angles
C. measuring bearings of the lines
D. none of the above

109. Which of the following is not used in measuring perpendicular offsets ?

A. line ranger
B. steel tape
C. optical square
D. cross staff

110. For a line AB_______________?

A. the forebearing of AB and back bearing of AB differ by 180°
B. the forebearing of AB and back bearing of BA differ by 180°
C. both (A. and (B. are correct.
D. none is correct